M1
S50
UID
UFUID
FUID
CUID
rc522
pn532
https://github.com/ikarus23/MifareClassicTool
https://github.com/ondryaso/pi-rc522
https://github.com/mxgxw/MFRC522-python
https://stackoverflow.com/questions/41326384/re-writing-uid-and-block-0-on-chinese-supposed-to-be-writable-mifare-1k-card-i
There are 2 types of UID writeble cards:
Block 0 writable cards: you can write block 0 at any moment
Backdoored cards
If writing block 0 does not work, you probably have a backdoored card: To enable the backdoor, you need to send the following sequence to the card: (everything in hexadecimal)
RC522 > Card: 50 00 57 cd (HLTA + CRC)
RC522 > Card: 40 (7 bits only)
Card > RC522: A (4 bits only)
RC522 > Card: 43
Card > RC522: A (4 bits only)
Then you can write to block 0 without authentication. If it still does not work, your card is probably not UID changeable.
芢聆湮苤: 褫夔岆 1024-byte 湮苤腔縐
楷冞: 50 00 57 cd
楷冞: 40 (7 bits)
彶善: a (4 bits)
楷冞: 43
彶善: 0a
Name Pin # Pin name
SDA 24 GPIO8
SCK 23 GPIO11
MOSI 19 GPIO10
MISO 21 GPIO9
IRQ None None
GND Any Any Ground
RST 22 GPIO25
3.3V 1 3V3
sudo raspi-config
spi
remote-gpio
sudo apt-get update
sudo apt-get upgrade
sudo apt-get install python3-dev python3-pip
sudo apt-get install python-spidev python3-spidev
???
sudo pip3 install spidev
sudo pip3 install mfrc522
git clone https://github.com/lthiery/SPI-Py.git
cd SPI-Py/
git checkout 8cce26b9ee6e69eb041e9d5665944b88688fca68
git checkout 8cce26b9ee6e69eb041e9d5665944b88688fca68
git checkout -b 8cce26b9ee6e69eb041e9d5665944b88688fca68
sudo python setup.py install
sudo python3 setup.py install
git clone https://github.com/mxgxw/MFRC522-python.git
cd MFRC522-python
python Read.py
注意：0扇区不能随意乱写，0扇区写不符合算法规则的数据会导致卡片锁死。
byte0-byte3 为UID
byte4 为check byte 算法 byte4 = byte0 ^ byte1 ^ byte2 ^ byte3
byte5为0x08
byte6 为0x04，
byte7 为0x00，Byte5,Byte6和byte7是m1卡片类型不可随意更改。
https://www.gushiciku.cn/pl/pi9z/zh-tw
https://www.tspweb.com/key/%E6%89%8B%E6%9C%BAnfc%E6%9A%B4%E5%8A%9B%E7%A0%B4%E8%A7%A3ic%E5%8D%A1%E5%AF%86%E9%92%A5.html
No comments:
Post a Comment